telecommunications, common-channel signaling (CCS), or common-channel interoffice signaling (CCIS), is the transmission of control information (signaling) via a separate...

referred to as common-channel signaling (CCS) protocols, or Common Channel Interoffice Signaling (CCIS) systems. Another element of in-band signaling addressed...

therefore, have their signaling channel in common. Compelled signaling refers to signaling where the receipt of each signal from an originating register...

Channel-associated signaling (CAS), also known as per-trunk signaling (PTS), is a form of digital communication signaling. As with most telecommunication...

Associated Signaling or NFAS is a Primary Rate Interface configuration whereby multiple T1 carriers share a signaling channel (or D channel). A T1 circuit...

human-imperceptible signaling technologies decreased. In-band signaling applies only to channel-associated signaling (CAS). In common channel signaling (CCS) separate...

Separate-channel signaling is a form of signaling in which the whole or a part of one or more channels in a multichannel system is used to provide for...

Architecture for Signaling Transport. RFC 2719 also defines the concept of a signaling gateway (SG), which converts Common Channel Signaling (CCS) messages...

IP. A SIGTRAN Signaling Gateway is a network component that performs packet level translation of signaling from common channel signaling (based upon SS7)...

signaling, for example common-channel signaling, refers to phone number and other digital control information rather than the actual voice signal. Signals...

supervision signaling on trunk lines between central offices. The signaling is sent in-band over the same channel as the bearer channel used for voice...

obsoleting single-frequency (SF) signaling. SF signaling was replaced by advanced methods of common channel signaling, a technology in development since the 1920s...

In telephony, single-frequency signaling (SF or SF tone) is line signaling in which dial pulses or supervisory signals are conveyed by a single-frequency...

discontinue the use of in-band signaling for call routing purposes. Instead, telecom companies began employing common-channel signaling (CCS), through which dialing...

replaced with out-of-band signaling methods in the form of common-channel signaling (CCS) carried digitally on a separate channel inaccessible to the telephone...

of common-channel signaling where message-based signalling for all subscribers uses the same signalling channel(s) rather than separate channels existing...

next call setup. It is sometimes, particularly in the context of common-channel signaling, called teardown. Removal of data from an automated information...

they used common-channel signaling in which the channels that are used for signaling are not used for message traffic (out of band signaling). Western...

A bearer channel is a DS-0 that carries call content i.e. one that does not carry signaling. In the common-channel signaling scheme for telecommunications...

integrated development environment for Texas Instruments processors Common-channel signaling, a method of transmitting control information complete corresponding...

over the peripheral unit bus. This includes the common channel interface signaling (CCIS) terminal, signal processors, time-slot interchanges (TSI) and time...

endocrine. Autocrine signaling occurs when the chemical signal acts on the same cell that produced the signaling chemical. Intracrine signaling occurs when the...

tone signalling which is passed through on the voice circuits themselves. More recent systems use common-channel signaling (CCS) such Signalling System...

Signaling System No. 6 (SS6) was introduced in the 1970s as an early common channel signalling method for telecommunication trunks between international...

Dae (September 1999). "Performability analysis of common-channel signaling networks, based on signaling system 7". IEEE Transactions on Reliability. 48...

differential signaling (LVDS), also known as TIA/EIA-644, is a technical standard that specifies electrical characteristics of a differential, serial signaling standard...

E and M signaling is a type of supervisory line signaling that uses DC signals on separate leads, called the "E" lead and "M" lead, traditionally used...

"Singular contributions to the development of the common-channel signaling network and the signal transfer points globally." This system began service...

The common-network interface ring (CNI ring) provides common-channel signaling (CCS) functionality on several Alcatel-Lucent SS7 products. It was introduced...

by which a signal transmitted on one circuit or channel of a transmission system creates an undesired effect in another circuit or channel. Crosstalk...