Actual cubic feet per minute (ACFM) is a unit of volumetric flow. It is commonly used by manufacturers of blowers and compressors. This is the actual...

Standard cubic feet per minute (SCFM) is the molar flow rate of a gas expressed as a volumetric flow at a "standardized" temperature and pressure thus...

for the cubic foot per minute is ft3/min. The following abbreviations are used: cu ft/min cufm cfm or CFM cfpm or CFPM Cubic feet per minute is used to...

[(60 °F + 459.67 °F) / (80 °F + 459.67 °F)] Vs = 4.16 scf Standard cubic feet per minute James E. Gallagher (2013). Natural Gas Measurement Handbook. Elsevier...

Cubic feet per Minute (SCFM) or litres per minute and pounds per square Inch (PSI) or bar. To a lesser extent, some compressors are rated in actual cubic...

extent, some compressors are rated in Actual Cubic Feet per Minute (ACFM). Still others are rated in Cubic Feet per Minute (CFM). Using CFM to rate a compressor...

= ventilation rate per person (cubic feet per minute (CFM) per person or cubic meters per minute per person) ACPH = Air changes per hour D = Occupant density...

Cement (including Portland cement), 4 cubic feet (113 L; 30 US gal) or 376 pounds (171 kg) Sugar, 5 cubic feet (142 L; 37 US gal) Wheat or rye flour,...

occupies a volume of 128 cubic feet (3.62 m3). This corresponds to a well-stacked woodpile, 4 feet deep by 4 feet high by 8 feet wide (122 cm × 122 cm ×...

{{\text{inches of water}}\cdot {\text{airflow}}}{8.5}}} Where airflow in Cubic Feet per Minute [CFM] is calculated using airflow = √13.35 × D2 / vacuum Where D...

cubic meters per second), kscm/h (thousand standard cubic meters per hour), LFM (linear feet per minute), or MMSCFD (million standard cubic feet per day)...

streams or rivers include m3/s (cubic meters per second), ft3/s (cubic feet per second or cfs) and/or acre-feet per day. A commonly applied methodology...

equivalent piston speed in feet per minute/33,000. For paddle ships, the Admiralty rule was that the piston speed in feet per minute was taken as 129.7 × (stroke)1/3...

given time. Expressed in cubic feet per minute or cubic meters per second/minute. Valve lift can be expressed as an actual dimension in decimal inches...

example, talk in acre-feet and cubic feet per second, whereas most other irrigation engineers would refer to gigaliters and cubic meters per second. Meteorology...

150 litres (5.3 cubic feet) per minute. If the cabin pressure drops below 600 hectopascals (0.59 standard atmospheres; 8.7 pounds per square inch), the...

by 54 feet (15 m × 16 m) and can spill up to 1,507,000 cubic feet per second (42,700 m3/s). The spillway empties into a stilling basin 950 feet (290 m)...

to make the opening large enough to provide intake air plus 1000 Cubic Feet per Minute (CFM) for additional ventilation. Engines pull sufficient air into...

"Flow" is the actual quantity of water falling from a site and is usually measured in gallons per minute, cubic feet per second, or liters per second. Low...

which contributes an average of 131 cubic feet per second (3.7 m3/s), resulting in a total of 6,169 cubic feet per second (174.7 m3/s), still significantly...

cubic feet (9.25 m3); 3–16: 30' long by 9'1" wide by 4' deep; 655.2 cubic feet (18.55 m3) and A–D: 27'5" long by 8' wide by 3' deep; 376.6 cubic feet...

Las Vegas. Excavation was underway in March 2019. Approximately 110,000 cubic yards (84,000 m3) of dirt and caliche were excavated to prepare the site...

that results from a Blower Door Test. The airflow, (Imperial in Cubic Feet / minute; SI in liters / second) at a given building-to-outside pressure differential...

of an actual panicked diver. The review found that a 1.7-cubic-foot (0.24 L) bottle had sufficient air to get the reviewing diver from 45 feet (14 m)...

top speed of 10 miles per hour (16 km/h). The standard freight cars on the tunnel were 12 feet 6 inches (3.81 m) long and 3 feet 11 inches (1.2 meters)...

requires about 160 cubic feet (4,500 L) of oxygen for a diver with a surface consumption rate of 0.5 cubic feet (14 L) per minute, and the Type 2 table...

the cylinder of 90 psi (6.2 bar) and a maximum piston speed of 1,000 feet per minute (5.1 m/s). The system introduced a somewhat progressive way of taxing...

miles per gallon of gasoline equivalent (MPGe). A gallon of gasoline equivalent means the number of kilowatt-hours of electricity, cubic feet of compressed...

an average flow of 540 cubic feet per minute, or 32,400 cubic feet (920 m3) per hour, dropping to 445 per minute (26,700 per hour) in late summer, and...

Calculated: "6608.9 trillion cubic feet" => 6608.9×103 billion cubic feet × 0.025 million tonnes of oil equivalent/billion cubic feet × 1×106 tonnes of oil equivalent/million...