resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors...

In electronic logic circuits, a pull-up resistor (PU) or pull-down resistor (PD) is a resistor used to ensure a known state for a signal. It is typically...

A resistor ladder is an electrical circuit made from repeating units of resistors, in specific configurations. An R–2R ladder configuration is a simple...

A resistor–capacitor circuit (RC circuit), or RC filter or RC network, is an electric circuit composed of resistors and capacitors. It may be driven by...

A Möbius resistor is an electrical component made up of two conductive surfaces separated by a dielectric material, twisted 180° and connected to form...

resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors...

indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others. A separate code...

Shift resistor may mean: CMOS digital level shifter Pull-up resistor This disambiguation page lists articles associated with the title Shift resistor. If...

example of a voltage divider is two resistors connected in series, with the input voltage applied across the resistor pair and the output voltage emerging...

A photoresistor (also known as a light-dependent resistor, LDR, or photo-conductive cell) is a passive component that decreases in resistance as a result...

electronics, a bleeder resistor, bleeder load, leakage resistor, capacitor discharge resistor or safety discharge resistor is a resistor connected in parallel...

characteristic. Ballasts vary greatly in complexity. They may be as simple as a resistor, inductor, or capacitor (or a combination of these) wired in series with...

Resistor–transistor logic (RTL), sometimes also known as transistor–resistor logic (TRL), is a class of digital circuits built using resistors as the input...

susceptibility is used to characterize the medium. Thermal noise in an ideal resistor is approximately white, meaning that its power spectral density is nearly...

bulbs, the full line voltage appears across the burnt out bulb. A shunt resistor, which has been connected in parallel across the filament before it burnt...

resistor (VCR) is a three-terminal active device with one input port and two output ports. The input-port voltage controls the value of the resistor between...

A potentiometer is a three-terminal resistor with a sliding or rotating contact that forms an adjustable voltage divider. If only two terminals are used...

A zero-ohm link or zero-ohm resistor is a wire link packaged in the same physical package format as a resistor. It is used to connect traces on a printed...

A varistor (a.k.a. voltage-dependent resistor (VDR)) is a surge protecting electronic component with an electrical resistance that varies with the applied...

The Starling resistor was invented by English physiologist Ernest Starling and used in an isolated-heart preparation during work which would later lead...

inventory simplification has led the industry to settle on the E series for resistors, capacitors, inductors, and zener diodes. Other types of electrical components...

A memristor (/ˈmɛmrɪstər/; a portmanteau of memory resistor) is a non-linear two-terminal electrical component relating electric charge and magnetic flux...

The thermal conductivity of a material is a measure of its ability to conduct heat. It is commonly denoted by k {\displaystyle k} , λ {\displaystyle \lambda...

with 178 Ω pull-up resistors on the multi-drop address and data lines and 383 Ω on the single-drop signal lines. Terminating resistor values of 78.7 ohms...

current (AC) amplitude across a resistor is R {\displaystyle R} , and that the AC voltage leads the current across a resistor by 0 degrees. This result is...

on one side of the resistor and the other), not the voltage itself, provides the driving force pushing current through a resistor. In hydraulics, it is...

constant, denoted τ (lowercase tau), the time constant (in seconds) of a resistor–capacitor circuit (RC circuit), is equal to the product of the circuit...

not on precise resistors. This makes them much more suitable for use within integrated circuits, where accurately specified resistors and capacitors are...

A liquid resistor is an electrical resistor in which the resistive element is a solution. Fixed-value liquid resistors are typically used where very high...

Diode logic (or diode-resistor logic) constructs AND and OR logic gates with diodes and resistors. An active device (vacuum tubes with control grids in...