10BASE2 (also known as cheapernet, thin Ethernet, thinnet, and thinwire) is a variant of Ethernet that uses thin coaxial cable terminated with BNC connectors...
9 KB (1,147 words) - 16:39, 5 October 2024
thick coaxial cable as a shared medium. This was largely superseded by 10BASE2, which used a thinner and more flexible cable that was both cheaper and...
58 KB (6,363 words) - 08:18, 26 September 2024
one Type C Mini-Centronics 36-pin parallel port. 600n – 10/100BASE-TX/10BASE2/LocalTalk (J3110A, J3111A, J3112A, J3113A) (Discontinued) 610n – Ethernet/Fast...
20 KB (1,658 words) - 13:46, 9 October 2024
Ethernet systems usually were 10BASE2, also known as thinnet. Apple's system is called FriendlyNet. A FriendlyNet 10BASE2 system does not use BNC T-connectors...
9 KB (1,043 words) - 15:38, 3 November 2024
120 ohm resistor. Dummy loads are commonly used in HF to EHF circuits. 10BASE2 networks absolutely must have proper termination with a 50 ohm BNC terminator...
8 KB (848 words) - 23:00, 13 September 2024
Attachment Unit Interface (AUI) connector to allow connection to legacy 10BASE2 or 10BASE5 network segments. Hubs are now largely obsolete, having been...
11 KB (1,396 words) - 19:38, 4 September 2024
detection are media dependent. On a shared, electrical bus such as 10BASE5 or 10BASE2, collisions can be detected by comparing transmitted data with received...
14 KB (1,956 words) - 16:50, 6 September 2024
networking of this period (mid 1980s to mid 1990s) used "thin coax" or 10BASE2. All devices on a network segment connected to the same electrical section...
4 KB (307 words) - 21:59, 6 May 2024
early computer networks, including ARCnet, the IBM PC Network, and the 10BASE2 variant of Ethernet. The BNC connector is used for signal connections such...
15 KB (1,713 words) - 13:36, 19 August 2024
superseded by much cheaper and more convenient alternatives: first by 10BASE2 based on a thinner coaxial cable (1985), and then, once Ethernet over twisted...
7 KB (818 words) - 12:31, 23 April 2024
tied together with 4 repeaters, with up to 3 mixing segments (10BASE5, 10BASE2, or 10BASE-FP). Link segments can be 10BASE-T, 10BASE-FL or 10BASE-FB....
7 KB (881 words) - 13:54, 4 October 2024
versions RG-58A/U or RG-58C/U was once widely used in "thin" Ethernet (10BASE2), for which it provides a maximum segment length of 185 meters. However...
3 KB (359 words) - 18:22, 19 December 2020
This was the layout used in the original Ethernet, called 10BASE5 and 10BASE2. This is still a common topology on the data link layer, although modern...
96 KB (11,333 words) - 03:40, 30 October 2024
Attachment Units (MAUs) in IEEE 802.3 documents and were widely used in 10BASE2 and 10BASE5 Ethernet networks. Fiber-optic gigabit, 10 Gigabit Ethernet...
7 KB (872 words) - 19:17, 27 March 2024
equipment that still had external AUI interfaces only, adapter-type MAUs with 10BASE2 or 10BASE-T connectors long remained available after the obsolescence of...
9 KB (974 words) - 18:39, 31 August 2024
400 MB, 660 MB, 1.4 GB or 2.8 GB SCSI drive Network interface: 10BASE-T and 10BASE2 Ethernet Expansion: four NeXTbus slots (mainboard uses one slot) Size (H...
5 KB (348 words) - 01:05, 26 April 2024
without inducing unwanted currents in them. Early Ethernet, 10BASE5 and 10BASE2, used baseband signaling over coaxial cables. The most common use for coaxial...
7 KB (796 words) - 06:05, 10 October 2024
bus: ISA 16-bit Connections for networking: 10BASE-T (8P8C), AUI (DA-15), 10BASE2 (BNC) Some of the possible ISA I/O bases are 0x280, 0x300, 0x310, 0x320...
10 KB (499 words) - 19:57, 2 May 2024
Etherpocket-SP parallel port Ethernet adapter (c. 1990). Supports both coaxial (10BASE2) and twisted pair (10BASE-T) cables. Power is drawn from a PS/2 port passthrough...
22 KB (2,648 words) - 17:04, 21 September 2024
RS-449, RS-485 Etherloop Ethernet physical layer Including 10BASE-T, 10BASE2, 10BASE5, 100BASE-TX, 100BASE-FX, 1000BASE-T, 1000BASE-SX and other varieties...
17 KB (1,701 words) - 21:45, 29 August 2024
electronic test equipment. Tee connectors were used to attach end stations to 10BASE2 Ethernet networks. Wikimedia Commons has media related to Tee connectors...
845 bytes (107 words) - 23:29, 11 December 2023
combination card features both a BNC connector (left) for use in (now obsolete) 10BASE2 networks and an 8P8C connector (right) for use in 10BASE-T networks. Connects...
17 KB (1,497 words) - 20:04, 30 July 2024
computer networks, in particular Ethernet ("thick" 10BASE5 and "thin" 10BASE2), twisted pair cables have replaced them in most applications except in...
76 KB (7,760 words) - 13:42, 31 October 2024
communication mechanism derived from Ethernet. The basic mode is based on 10BASE2, but higher-data-rate encodings for application such as video streaming...
9 KB (921 words) - 22:48, 27 September 2023
RS-232, EIA-422, EIA-423, RS-449, RS-485 Ethernet physical layer 10BASE-T, 10BASE2, 10BASE5, 100BASE-TX, 100BASE-FX, 1000BASE-T, 1000BASE-SX and other varieties...
11 KB (970 words) - 17:09, 13 October 2024
000,000 1,250,000 Networking 107 bit/s is the speed of classic Ethernet: 10BASE2, 10BASE5, 10BASE-T 10 Mbit/s 10,000,000 1,250,000 Biology Research suggests...
17 KB (876 words) - 12:52, 1 October 2024
standard 802.3i called 10BASE-T, itself an evolution of 10BASE5 (802.3) and 10BASE2 (802.3a). Fast Ethernet devices are generally backward compatible with...
32 KB (2,862 words) - 07:11, 15 September 2024
IBM-compatible mainframe system MultiConnect (?) was a chassis-based multi-port 10BASE2 Ethernet repeater. 3Server, a server-grade PC for running 3+ services....
28 KB (3,050 words) - 15:08, 4 November 2024
SBus cards were announced in 1989 by Antares Microsystems; these were a 10BASE2 Ethernet controller, a SCSI-SNS host adapter, a parallel port, and an 8-channel...
5 KB (677 words) - 00:13, 5 July 2024
between networked devices using a shared medium. In the original 10BASE5 and 10BASE2 Ethernet varieties, a segment would therefore correspond to a single coax...
3 KB (386 words) - 15:35, 8 July 2024