heat pipe is a heat-transfer device that employs phase transition to transfer heat between two solid interfaces. At the hot interface of a heat pipe,...
59 KB (7,598 words) - 13:43, 21 August 2024
A loop heat pipe (LHP) is a two-phase heat transfer device that uses capillary action to remove heat from a source and passively move it to a condenser...
7 KB (942 words) - 17:08, 9 June 2024
of pipe wall can be expressed as a "heat transfer coefficient of the pipe wall". However, one needs to select if the heat flux is based on the pipe inner...
26 KB (4,427 words) - 10:13, 20 August 2024
fundamental rules for all heat exchangers are the same. 1. Double-pipe heat exchanger When one fluid flows through the smaller pipe, the other flows through...
68 KB (9,313 words) - 01:30, 19 October 2024
Thermosiphon (section Heat pipes)
wick allows heat pipes to transfer heat when there is no gravity, which is useful in space. A thermosiphon is "simpler" than a heat pipe. (Single-phase)...
14 KB (1,901 words) - 15:07, 14 October 2024
Heat-pipe tectonics is a cooling mode of terrestrial planets and moons in which the main heat transport mechanism in the planet is volcanism through the...
27 KB (2,575 words) - 13:27, 11 August 2024
Thermal management (electronics) (redirect from Size vs. heat)
airflow can result in less dust build up if filtered properly A heat pipe is a heat transfer device that uses evaporation and condensation of a two-phase...
30 KB (3,931 words) - 20:34, 1 November 2024
A micro-loop heat pipe or MLHP is a miniature loop heat pipe in which the radius of curvature of the liquid meniscus in the evaporator is in the same...
755 bytes (73 words) - 03:46, 27 August 2024
District heating (redirect from Steam Pipe)
pipe, say 80 ˚C and coupled to the return pipe, at e.g. 40 ˚C. By adding a heat pump locally to this user, the 40 ˚C pipe is cooled further (the heat...
132 KB (14,150 words) - 20:42, 1 November 2024
the heat pipe to the other through pressure, wick forces or gravity, depending on the arrangement of the heat pipe. Run-around systems are hybrid heat recovery...
35 KB (5,176 words) - 00:06, 11 September 2024
sinks are the heat exchangers used in refrigeration and air conditioning systems or the radiator in a car. A heat pipe is another heat-transfer device...
66 KB (8,490 words) - 11:18, 7 October 2024
Plumbing (redirect from Water pipe)
protection Copper pipe Domestic water system Double-walled pipe EPA Lead and Copper Rule Fire hose Flange Garden hose HDPE pipe Heat pipe Hose MS Pipe, MS Tube...
42 KB (4,865 words) - 01:17, 18 September 2024
used in large chillers or in more particular applications like heat pipe finned heat exchangers. In addition, 1,1-difluoroethane is also commonly used...
12 KB (1,030 words) - 13:21, 30 October 2024
using a scarfing blade. The weld zone can also be heat-treated to make the seam less visible. Welded pipe often has tighter dimensional tolerances than the...
44 KB (6,161 words) - 14:35, 21 October 2024
a heat sink: increase the base thickness, choose a different material with higher thermal conductivity, use a vapor chamber or heat pipe in the heat sink...
48 KB (5,894 words) - 02:14, 29 October 2024
A heat pump is a device that consumes energy (usually electricity) to transfer heat from a cold heat sink to a hot heat sink. Specifically, the heat pump...
75 KB (8,267 words) - 16:49, 31 October 2024
heat transfer) is the transfer of heat from one place to another due to the movement of fluid. Although often discussed as a distinct method of heat transfer...
10 KB (1,283 words) - 15:10, 16 August 2024
early Earth's internal heat loss could have been dominated by advection via heat-pipe volcanism. Terrestrial bodies with lower heat flows, such as the Moon...
18 KB (2,115 words) - 11:18, 20 August 2024
heater Grease duct Grille Ground-coupled heat exchanger Ground source heat pump Heat exchanger Heat pipe Heat pump Heating film Heating system HEPA High...
9 KB (1,149 words) - 04:23, 21 August 2024
Heat traps are valves or loops of pipe on the cold water inlet and hot water outlet of water heaters. The heat traps allow cold water to flow into the...
3 KB (282 words) - 20:45, 28 March 2024
refrigerant as a heat transfer medium. The heat pipe uses multiple sealed pipes mounted in a coil configuration with fins to increase heat transfer. Heat is absorbed...
17 KB (2,299 words) - 16:41, 8 October 2024
active heat spreader speeds up heat transfer with expenditure of energy as work supplied by an external source. A heat pipe uses fluids inside a sealed case...
6 KB (700 words) - 05:43, 1 February 2024
Hydronics (section Single-pipe steam)
hydronic heating technology, a single-pipe steam system delivers steam to the radiators where the steam gives up its heat and is condensed back to water. The...
15 KB (2,055 words) - 10:51, 1 May 2024
Latent heat (also known as latent energy or heat of transformation) is energy released or absorbed, by a body or a thermodynamic system, during a constant-temperature...
21 KB (2,520 words) - 02:35, 4 November 2024
facilities as of early 2020. The reactor design is a fast-neutron reactor with heat pipe cooling similar to the NASA Kilopower reactor. According to the designers...
6 KB (533 words) - 22:47, 12 October 2024
Thermostat (redirect from Thermostatic heat control)
near a desired setpoint. Thermostats are used in any device or system that heats or cools to a setpoint temperature. Examples include building heating, central...
43 KB (5,311 words) - 00:20, 30 October 2024
Sensible heat is heat exchanged by a body or thermodynamic system in which the exchange of heat changes the temperature of the body or system, and some...
4 KB (530 words) - 11:23, 15 August 2024
through the pipe). Since pipework can operate at temperatures far removed from the ambient temperature, and the rate of heat flow from a pipe is related...
14 KB (1,812 words) - 22:10, 3 August 2024
Thermal insulation (redirect from Heat insulator)
and cooling systems distribute heat throughout buildings by means of pipes or ductwork. Insulating these pipes using pipe insulation reduces energy into...
15 KB (1,771 words) - 16:38, 28 October 2024
requirements and associated heat emissions result in greater demands on cooling systems. A heat pipe typically consists of a sealed pipe or tube at both the hot...
33 KB (4,242 words) - 14:46, 13 January 2024