resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors...

In electronic logic circuits, a pull-up resistor (PU) or pull-down resistor (PD) is a resistor used to ensure a known state for a signal. It is typically...

A resistor ladder is an electrical circuit made from repeating units of resistors, in specific configurations. An R–2R ladder configuration is a simple...

A Möbius resistor is an electrical component made up of two conductive surfaces separated by a dielectric material, twisted 180° and connected to form...

A resistor–capacitor circuit (RC circuit), or RC filter or RC network, is an electric circuit composed of resistors and capacitors. It may be driven by...

resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors...

indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others. A separate code...

example of a voltage divider is two resistors connected in series, with the input voltage applied across the resistor pair and the output voltage emerging...

characteristic. Ballasts vary greatly in complexity. They may be as simple as a resistor, inductor, or capacitor (or a combination of these) wired in series with...

susceptibility is used to characterize the medium. Thermal noise in an ideal resistor is approximately white, meaning that its power spectral density is nearly...

electronics, a bleeder resistor, bleeder load, leakage resistor, capacitor discharge resistor or safety discharge resistor is a resistor connected in parallel...

A photoresistor (also known as a light-dependent resistor, LDR, or photo-conductive cell) is a passive component that decreases in resistance as a result...

Resistor–transistor logic (RTL), sometimes also known as transistor–resistor logic (TRL), is a class of digital circuits built using resistors as the input...

A potentiometer is a three-terminal resistor with a sliding or rotating contact that forms an adjustable voltage divider. If only two terminals are used...

bulbs, the full line voltage appears across the burnt out bulb. A shunt resistor, which has been connected in parallel across the filament before it burnt...

A zero-ohm link or zero-ohm resistor is a wire link packaged in the same physical package format as a resistor. It is used to connect traces on a printed...

A varistor (a.k.a. voltage-dependent resistor (VDR)) is a surge protecting electronic component with an electrical resistance that varies with the applied...

current (AC) amplitude across a resistor is R {\displaystyle R} , and that the AC voltage leads the current across a resistor by 0 degrees. This result is...

NYC Resistor is a restricted membership private club hackerspace with approximately 50 members in New York, inspired by Chaos Computer Club and other hacker...

not on precise resistors. This makes them much more suitable for use within integrated circuits, where accurately specified resistors and capacitors are...

constant, denoted τ (lowercase tau), the time constant (in seconds) of a resistor–capacitor circuit (RC circuit), is equal to the product of the circuit...

inventory simplification has led the industry to settle on the E series for resistors, capacitors, inductors, and zener diodes. Other types of electrical components...

Shift resistor may mean: CMOS digital level shifter Pull-up resistor This disambiguation page lists articles associated with the title Shift resistor. If...

resistor (VCR) is a three-terminal active device with one input port and two output ports. The input-port voltage controls the value of the resistor between...

A memristor (/ˈmɛmrɪstər/; a portmanteau of memory resistor) is a non-linear two-terminal electrical component relating electric charge and magnetic flux...

The thermal conductivity of a material is a measure of its ability to conduct heat. It is commonly denoted by k {\displaystyle k} , λ {\displaystyle \lambda...

with 178 Ω pullup resistors on the multi-drop address and data lines and 383 Ω on the single-drop signal lines. Terminating resistor values of 78.7 ohms...

on one side of the resistor and the other), not the voltage itself, provides the driving force pushing current through a resistor. In hydraulics, it is...

A resistor–inductor circuit (RL circuit), or RL filter or RL network, is an electric circuit composed of resistors and inductors driven by a voltage or...

A loss free resistor (LFR) is a resistor that does not lose energy. The first implementation was due to Singer and it has been implemented in various settings...