Beechcraft Starship

This article's lead section may be too short to adequately summarize the key points. Please consider expanding the lead to provide an accessible overview of all important aspects of the article. (June 2023)

Model 2000 Starship
General information
Type	Executive transport
Manufacturer	Beechcraft
Status	In limited use
Number built	53
History
Manufactured	1983–1995
First flight	February 15, 1986

The Beechcraft Starship is a twin-turboprop six- to eight-passenger pressurized business aircraft produced by Beech Aircraft Corporation. Notable for its unusual canard design and extensive use of carbon fiber composite, it did not sell many units and production ceased in 1995, only nine years after the Starship's first flight.

Development of the Starship began in 1979 when Beech decided to explore designs for a successor to its King Air line of turboprops that would fly faster and carry more passengers.^[1] The design was originated by Beechcraft in January 1980 as Preliminary Design 330 (PD 330).^{[citation needed]}

On August 25, 1982, Beech contracted with Scaled Composites to refine the design and build an 85% scale proof-of-concept (POC) aircraft.^[1][2] One of the significant changes made to the design by Scaled Composites was the addition of variable geometry to the canard.^[3]

The POC aircraft first flew in August 1983.^[4] This aircraft had no pressurization system, no certified avionics, and a different airframe design and material specifications from the planned production Model 2000. Only one POC was built and it has since been scrapped.^[1]

Prototypes were produced even as development work was continuing—a system demanded by the use of composite materials, as the tooling required is very expensive and has to be built for production use from the outset. Beech built three airworthy full-scale prototypes. NC-1 was used for aerodynamic testing^[4] and had an ejection seat. This was the only Starship equipped with conventional electro-mechanical avionics.^[5] NC-2 was used for avionics and systems testing and NC-3 was used for flight management system and powerplant testing.^[4] NC-1 first flew on February 15, 1986.^[4]

The program was delayed several times, at first due to underestimating the developmental complexity and manufacturing learning curve of the production composite construction, and later due to the technical difficulties of correcting a pitch damping problem and developing the stall-warning system. By the end of development, the Starship had grown larger in cabin volume than the King Air 350 while having the same gross ramp weight of 15,010 lb (6,808 kg). Starship development cost $300 million.^[6] The first production Starship flew on April 25, 1989.^[7][8]

The Starship is noteworthy for its unconventional carbon fiber composite airframe, canard design, lack of centrally located vertical tail, and pusher engine/propeller configuration. The aircraft employs a variable-sweep canard surface in order to counteract the nose-down pitch from extending the flaps.^[9]

Carbon fiber composite was used to varying degrees on military aircraft, but at the time the Starship was certified, no civilian aircraft certified by the U.S. Federal Aviation Administration had ever used it so extensively. Beech chose carbon fiber composite for its durability and high strength-to-weight ratio. According to Beech, the Starship weighs less than it would have if it were built from aluminum. Nonetheless, the empty weight of production aircraft exceeded the target by several thousand pounds.^[10][11][12]

Beech studied several configurations before settling on a canard configuration in early 1980.^[13] As configured, the Starship is difficult to stall; the forward surface stalls before the main lifting surface, which allows the nose to drop and more-normal flight to resume.^[14]

A traditionally located vertical tail would have transmitted propeller noise into the airframe.^[15] In its place, directional stability and control is provided by rudders mounted on the winglets. Because of this addition Beechcraft called the winglets "tipsails".^[16][17]

Mounting the engines so that the propellers are facing rearward, pushing rather than pulling the aircraft, is done for the purpose of a quieter cabin, since the propellers are further back from the passengers and because vortices from the propeller tips do not strike the fuselage sides. However, the propellers are operating in a turbulent airflow in the pusher configuration (due to airflow past the wings moving aft in vortex sheets) and high-velocity exhaust gases are discharged directly into the propellers, producing more noise where they are than if the propellers had been in a tractor configuration.^{[citation needed]}

Flight instrumentation for the Starship included a 14-tube Proline 4 AMS-850 "glass cockpit" supplied by Rockwell Collins, the first application of an all-glass cockpit in a business aircraft.^[1]

Beech sold only eleven Starships in the three years following its certification. Beech attributed the slow sales to the economic slowdown in the late-1980s, the novelty of the Starship, and the tax on luxury items that was in effect in the United States at the time. However,

Reasons for the lack of demand probably included price, performance, and economic conditions. The list price in 1989 was $3.9 million, similar to the Cessna Citation V and Lear 31 jets, which were 89 and 124 knots faster than the Starship at maximum cruise, respectively. The Piper Cheyenne turboprop was faster and sold for $1 million less.^[18]

In an effort to stimulate demand, Beech began offering two-year leases on new Starships in 1991.^[19] One of the Starships appeared in the opening scenes of the Murder, She Wrote TV series episode "Terminal Connection" in 1991.

The last Starship, NC-53, was produced in 1995. In 2003 Beechcraft said that supporting such a small fleet of airplanes was cost-prohibitive and began scrapping and incinerating the aircraft under its control. The aircraft were sent to the Evergreen Air Center located at the Pinal Airpark in Arizona for destruction.^{[citation needed]} Beech worked with owners of privately owned Starships to replace their airplanes with other Beech aircraft such as the Premier I jet.^[20][21]

In 2004, Raytheon sold off its entire inventory of Starship parts to a Starship owner for a fraction of its retail value.^[22]

Model 115

Conceptual 85% scale prototype, one built by Scaled Composites. Scrapped by Beech at Mojave Airport in 1990.^[23]

Model 2000

Initial production version. 20 produced including three pre-production airworthy prototypes.^[24][25]

Model 2000A

Beech did not serialise the 2000A as a distinct model and it was not issued a new FAA type certificate.^[26][27]

The final 2000A configuration had tuning-fork-type noise dampers and improved insulation to reduce cabin noise and redesigned exhaust stacks for more efficient engine airflow. Stall strips placed on the front wing to enhance stall behavior were removed. Elimination of the stall strips reduced stall speed by up to 9 knots (10 mph; 17 km/h), which allows the 2000A to takeoff from shorter runways.^[10] The 2000 had standpipes in the fuel tanks to artificially limit fuel capacity so the aircraft would meet a target payload weight. The standpipes were removed in the 2000A, increasing fuel capacity by 31 US gal (117 L).^[27] Both the maximum ramp weight and takeoff weight were increased by 500 lb (227 kg) and zero fuel weight was increased 400 lb (181 kg).^[27]

Beech produced a kit to upgrade serial numbers NC-4 through NC-20 to 2000A specifications.^[27]

Several Starships have been donated to museums since the decommissioning program began. The Kansas Aviation Museum received the first donated aircraft, NC-41, in August 2003^[28][29] and the Beechcraft Heritage Museum in Tullahoma, TN, received the second donated aircraft, NC-49, in September 2003.^[30][31] NC-42 was donated to the Museum of Flight in Seattle, WA, and is currently on loan to the Future of Flight at Paine Field in Everett, WA.^[32] NC-27 was donated to Evergreen Aviation & Space Museum in McMinnville, Oregon in late 2003 and is currently on static display.^[33][34] NC-23 is on Airline Row at the Pima Air & Space Museum.^[35] NC-6 is on display in Liberal, KS, at the Mid-America Air Museum. Aircraft NC-28 is on display at the Queensland Air Museum,^[36] after it was used by the Queensland Institute for Aviation Engineering in Caloundra.^[37][38] Aircraft NC-14 is on display outside at the Southern Museum of Flight.

In 2003 Evergreen Air Center sold 8 Starships back to private owners for $50,000 each. Most are being used for parts; however, one of these aircraft has since been made airworthy again.^[22] Some former Starship parts have been used on the Epic turboprop kitplane.^[39]

As of January 2010^[update], nine Starships held an active registration with the FAA. Three Starships were registered in Oklahoma (NC-29, NC-35 & NC-45), one in Texas (NC-50), one in Colorado (NC-51), and four were registered to Beechcraft in Wichita, Kansas (NC-2, NC-8, NC-19 & NC-24).^[40] NC-51 was used as a chase plane during the re-entry phase of Burt Rutan's SpaceShipOne.^[41] In October 2008 NC-29 was the first of the five remaining privately owned airworthy Starships to complete RVSM certification, returning the aircraft's service ceiling to the original FL410 limit.^[42]

Salt Lake Community College used a Starship in their Aviation Maintenance program until late 2012 when it was sold and scrapped for parts.^[43][44]

As of September 2020, only six Starships are airworthy. Two Beechcraft Starships (NC-33 and NC-50) are located in Addison, Texas. NC-33 lost its data plate when it was scrapped, was subsequently registered in Mexico, but when brought back to the US, the FAA revoked its certificate. It is now registered in the experimental category as N903SC.^[45] The other airworthy Starships are located in Oklahoma (NC-35 and NC-45), Colorado (NC-51), and Germany (NC-29, though registered with the FAA by a company in Delaware).

Data from Flying Magazine,^[10] NC-53 POH,^[46] except where noted

General characteristics

• Crew: 1 or 2^[46]
• Capacity: 6
• Length: 46 ft 1 in (14.05 m)
• Wingspan: 54 ft 5.70 in (16.6 m)
• Height: 12 ft 1.3 in (3.94 m)
• Wing area: 281 sq ft (26.1 m²)
• Empty weight: 10,085 lb (4,574 kg) standard empty weight
• Gross weight: 15,010 lb (6,808 kg) max ramp weight
• Max takeoff weight: 14,900 lb (6,759 kg)
• Fuel capacity: 565 gallons, or 3785 lbs.^[46]
• Powerplant: 2 × Pratt & Whitney Canada PT6A-67A turboprop, 1,200 shp (890 kW) each
• Propellers: 5-bladed McCauley, 8 ft 8 in (2.64 m) diameter

Performance

• Maximum speed: 385 mph (620 km/h, 335 kn)
• Cruise speed: 353 mph (568 km/h, 307 kn)
• Stall speed: 112 mph (180 km/h, 97 kn) max weight with flaps retracted & idle power^[46]
• Minimum control speed: 108 mph (174 km/h, 94 kn) flaps retracted^[46]
• Range: 1,742 mi (2,804 km, 1,514 nmi)
• Service ceiling: 41,000 ft (12,500 m)
• Rate of climb: 2,748 ft/min (13.96 m/s)
• Wing loading: 53 lb/sq ft (260 kg/m²)
• Power/mass: 6.2 lb/shp

Aircraft of comparable role, configuration, and era

• AAC Angel
• AASI Jetcruzer
• Adam A500
• Avtek 400A
• Embraer/FMA CBA 123 Vector
• LearAvia Lear Fan
• OMAC Laser 300
• Piaggio P.180 Avanti

• Warwick, Graham (May 3, 1986), "Beech's enterprising Starship" (PDF), Flight International, 129 (4009), flightglobal.com: 18–24, ISSN 0015-3710

Wikimedia Commons has media related to Beechcraft Starship.

• The Starship Diaries
• A Collection of Beechcraft Starship 2000A Material
• Video on YouTube Detailed Beechcraft Starship (of aircraft N903SC) walkaround