Menai Suspension Bridge

Menai Bridge Pont Grog y Borth
The Menai Suspension Bridge viewed from the Anglesey side
Coordinates	53°13′12″N 4°9′47″W / 53.22000°N 4.16306°W / 53.22000; -4.16306
Carries	A5 (London to Holyhead)
Crosses	Menai Strait
Locale	Anglesey, North West Wales
Heritage status	Grade 1
Characteristics
Design	Suspension bridge
Material	Wrought iron (original chains) Steel (replacement chains) Stone Cast iron
Total length	417 metres (1,368 ft)
Width	12 metres (39 ft)
Longest span	176 metres (577 ft)
No. of spans	Main: One Arches: Seven
Piers in water	Five
Clearance below	31 metres (102 ft)
Design life	1893: wooden deck replaced in steel 1938/40: iron chains replaced in steel
History
Designer	Thomas Telford
Construction start	1819; 205 years ago (1819)
Opened	30 January 1826; 198 years ago (1826-01-30)
Location

The Menai Suspension Bridge (Welsh: Pont y Borth or Pont Grog y Borth) is a suspension bridge spanning the Menai Strait between the island of Anglesey and the mainland of Wales. Designed by Thomas Telford and completed in 1826, it was the world's first major suspension bridge.^[1] The bridge still carries road traffic and is a Grade I listed structure.^[2]

The Menai Strait was created by glacial erosion along a line of weakness associated with the Menai Strait fault system. During a series of Pleistocene glaciations (that lasted from about 2,580,000 to 11,700 years ago), a succession of ice-sheets moved from northeast to southwest across Anglesey and neighbouring Gwynedd, scouring the underlying rock and creating a series of linear bedrock hollows. The deepest of these channels eventually became flooded by the sea as the ice sheets receded, forming the Menai Strait.^[3]

As Anglesey has been an island throughout recorded human history, the only way to reach it was by crossing the strait. However, this has always been a dangerous endeavour because there are four strong tidal flows each day generated by the twice daily tides. These flow in both directions through the strait, creating strong currents and whirlpools. Despite the dangers, ferries operated all along the Menai Strait, carrying passengers and goods between the island and the mainland. In 1785, a boat carrying 55 people ran aground at the southern end of the Menai Strait in a strong gale and began to sink. The stricken vessel sank before a rescue boat from Caernarfon could reach it, and only one person survived.^[4]

Additionally, the main source of income on Anglesey was from the sale of cattle, and to move them to the markets of the mainland, including London, they had to be driven into the water and encouraged to swim across the Strait. This often resulted in the loss of valuable animals.^[5]

In 1800, Ireland joined Great Britain in the Act of Union. This led rapidly to an increase in people travelling between London and Holyhead en route to Dublin. In 1815, the British Parliament passed an act of Parliament, the Holyhead Roads Act 1815 (55 Geo. 3. c. 152), to build the Holyhead Road with responsibility for the project given to civil engineer Thomas Telford. Despite some difficult geographical obstacles to overcome (e.g. Snowdonia and the Menai Strait), the route was chosen because Holyhead was the principal port for ferries to Dublin as it was the closest point to Ireland. After Telford had completed a survey of the route from London to Holyhead, he proposed that the best option was to build a bridge over the Menai Strait from a point near Bangor on the mainland to the village of Porthaethwy (now commonly known as Menai Bridge) on Anglesey.^[5]

The site for the bridge was chosen because it had tall banks that would be high enough to allow sailing ships to pass underneath. Telford proposed that a suspension bridge would be the best option because it would have a span wide enough to cross the fast flowing waters of the Strait at this point. His recommendation was accepted by Parliament, which authorised the bridge in the Roads Between London and Holyhead Act 1819 (59 Geo. 3. c. 48).^[5]

Construction of the bridge, to Telford's design, began in 1819 with the towers on either side of the strait. These were constructed from Penmon limestone and were hollow with internal cross-walls. Then came the sixteen huge chain cables to support the 176-metre (577 ft) span, each consisting of five parallel bars of wrought iron links, for a total of 80 iron bars and 935 links per cable.^[6][7]

The chains were carried over the piers on cast iron saddles with rollers, allowing for movement caused by temperature changes.^[6] Each chain measured 522.3 metres (1,714 ft) and weighed 121 long tons (123 t; 136 short tons). Their suspending power was calculated at 2,016 long tons (2,048 t; 2,258 short tons).^[5] To avoid rusting between manufacture and use, the iron was soaked in linseed oil and later painted.^[8] On both sides of the strait the chains were conveyed through three tunnels into a chamber cut into the rock, where they were held in place by 9 feet (2.7 m) bolts resting in cast iron sockets.^[6] William Hazledine was contracted to supply the necessary wrought and cast iron, and each chain had four adjusting links to compensate for differences in length caused by imperfections during the production of the large number of separate links.^[6][9]

Workmen assembled the majority of the chains link by link on-site. This was carried out on platforms near the tunnel mouths until the chains, supported by scaffolding, reached the tops of the piers. A cradle capable of carrying two workers was then suspended from each tower and links were lifted up and attached by the men in the cradles until the chains reached water level. The final central portion of each chain was floated across on a 400 feet (120 m) raft and lifted via a system of pulleys by 150 men.^[6]

The bridge was opened to much fanfare on 30 January 1826. It reduced the 36-hour journey time from London to Holyhead by 9 hours.^[5][9]

The roadway was only 24 feet (7.3 m) wide and, without stiffening trusses, soon proved highly unstable in the wind. The deck of the Menai Bridge was strengthened in 1840 by W. A. Provis and, in 1893, the entire wooden surface was replaced with a steel deck designed by Sir Benjamin Baker.^[10] Over the years, the 41⁄2-ton weight limit proved problematic for the increasing freight industry and in 1938 the original wrought iron chains were replaced by a new arrangement of steel ones, without the need to close the bridge. In 1999, the bridge was closed for around a month to resurface the road and strengthen the structure, requiring all traffic to cross via the nearby Britannia Bridge.

On 28 February 2005, one carriageway of the bridge was closed for six months, restricting traffic to a single carriageway. The bridge was reopened to traffic in both directions on 11 December 2005 after its first major repainting in 65 years.^[11] It has been proposed by the British government as a candidate World Heritage Site.^[12]

On 21 October 2022, the bridge was shut without prior notice. A statement from the Welsh Government said it was closed for essential maintenance work following safety recommendations from structural engineers.^[13] Initially, the bridge was shut completely in both directions, but it was soon reopened to foot passengers and dismounted cyclists. The Welsh Government stated the bridge will remain closed for 14 to 16 weeks, reopening in early 2023.^[14]

On 1 February 2023, the bridge was reopened in both directions, but subject to a seven and a half ton weight restriction. A date for full remedial work has yet to be set.^[15]

The Anglesey Coastal Path passes below the bridge and the Wales coast path passes over the bridge and joins the mainland path at the bridge end. The bridge has a memorial to the Aberfan disaster victims on the Anglesey side.^{[citation needed]}

The nearest settlement is the town of Menai Bridge. A representation of the Menai Bridge inside a border of railings and stanchions is featured on the reverse of British one-pound coins minted in 2005.^[16]

White Knight to Alice:
"I heard him then, for I had just
completed my design,
To keep the Menai bridge from rust
By boiling it in wine."

— "Haddocks' Eyes", Through the Looking-Glass, Lewis Carroll

Uchelgaer uwch y weilgi – gyr y byd
Ei gerbydau drosti,
Chwithau, holl longau y lli,
Ewch o dan ei chadwyni.

— Dewi Wyn o Eifion^[17]

High fortress above the sea – the world drives
Its carriages across it;
And you, all you ships of the sea,
Pass beneath its chains.

— David Owen (1784–1841)

• Britannia Bridge, second bridge over the Menai Strait, opened in 1850
• Menai Heritage Bridges Exhibition, museum about the Menai and Britannia bridges
• List of bridges in Wales
• Swellies
• Operation Menai Bridge

Wikimedia Commons has media related to Menai Suspension Bridge.

• Menai Bridge Website Menai Bridge Town Partnership Website with details on the news, council, events and businesses of Menai Bridge
• Menai Heritage A community project and museum celebrating the two bridges and the town of Menai Bridge

Listen to this article (4 minutes)

This audio file was created from a revision of this article dated 6 March 2006 (2006-03-06), and does not reflect subsequent edits.

(Audio help · More spoken articles)

• Menai Strait Bridge at Structurae