Methacrylic acid

Methacrylic acid
Structural formula of methacrylic acid
Ball-and-stick model of the methacrylic acid molecule
Names
IUPAC name
Methacrylic acid[1]
Preferred IUPAC name
2-Methylprop-2-enoic acid
Other names
Methacrylic acid
2-Methyl-2-propenoic acid
α-Methacrylic acid
2-Methylacrylic acid
2-Methylpropenoic acid
Identifiers
3D model (JSmol)
Abbreviations MAA
ChEBI
ChemSpider
ECHA InfoCard 100.001.096 Edit this at Wikidata
EC Number
  • 201-204-4
MeSH C008384
UNII
  • InChI=1S/C4H6O2/c1-3(2)4(5)6/h1H2,2H3,(H,5,6)
    Key: CERQOIWHTDAKMF-UHFFFAOYSA-N
  • CC(C(O)=O)=C
Properties
C4H6O2
Molar mass 86.09 g/mol
Appearance Colorless liquid
Odor Acrid, repulsive[2]
Density 1.015 g/cm3
Melting point 14 to 15 °C (57 to 59 °F; 287 to 288 K)
Boiling point 161 °C (322 °F; 434 K)
9% (25 °C)[2]
Vapor pressure 0.7 mmHg (20 °C)[2]
Hazards
NFPA 704 (fire diamond)
NFPA 704 four-colored diamondHealth 3: Short exposure could cause serious temporary or residual injury. E.g. chlorine gasFlammability 2: Must be moderately heated or exposed to relatively high ambient temperature before ignition can occur. Flash point between 38 and 93 °C (100 and 200 °F). E.g. diesel fuelInstability 2: Undergoes violent chemical change at elevated temperatures and pressures, reacts violently with water, or may form explosive mixtures with water. E.g. white phosphorusSpecial hazards (white): no code
3
2
2
Flash point 77.2 °C (171.0 °F; 350.3 K)
NIOSH (US health exposure limits):
PEL (Permissible)
none[2]
REL (Recommended)
TWA 20 ppm (70 mg/m3) [skin][2]
IDLH (Immediate danger)
N.D.[2]
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
☒N verify (what is checkY☒N ?)

Methacrylic acid, abbreviated MAA, is an organic compound with the formula CH2=C(CH3)CO2H. This colorless, viscous liquid is a carboxylic acid with an acrid unpleasant odor. It is soluble in warm water and miscible with most organic solvents. Methacrylic acid is produced industrially on a large scale as a precursor to its esters, especially methyl methacrylate (MMA), and to poly(methyl methacrylate) (PMMA).

Production

[edit]

In the most common route, methacrylic acid is prepared from acetone cyanohydrin, which is converted to methacrylamide sulfate using sulfuric acid. This derivative in turn is hydrolyzed to methacrylic acid, or esterified to methyl methacrylate in one step. Another route to methacrylic acid starts with isobutylene, which obtainable by dehydration of tert-butanol. Isobutylene is oxidized sequentially to methacrolein and then methacrylic acid. Methacrolein for this purpose can also be obtained from formaldehyde and ethylene. Yet a third route involves the dehydrogenation of Isobutyric acid.[3]

Various green routes have been explored but they have not been commercialized. Specifically, the decarboxylation of itaconic acid, citraconic acid, and mesaconic acids affords methacrylic acid.[4] Salts of methacrylic acid have been obtained by boiling citra- or meso-brompyrotartaric acids with alkalis.[citation needed]

Pyrolysis of ethyl methacrylate efficiently gives methacrylic acid.[5]

Uses and occurrence

[edit]

The main use of methacrylic acid is its polymerization to poly(methyl methacrylate).[6]

It is used in some nail primers to help acrylic nails adhere to the nail plate.[7]

Copolymers consisting partially of methacrylic acid are used in certain types of tablet coatings in order to slow the tablet's dissolution in the digestive tract, and thus extend or delay the release of the active ingredient.[8]

MAA occurs naturally in small amounts in the oil of Roman chamomile.[citation needed]

MMA is used in the synthesis of some vinyl ester resins.

Typical vinyl ester resin derived from bisphenol A diglycidyl ether and methacrylic acid.[9]

Reactions

[edit]

For commercial applications, MAA is polymerized using azobisisobutyronitrile as a thermally activated free-radical catalyst. Otherwise, MAA is relatively slow to polymerize thermally or photochemically.[6]

Methacrylic acid undergoes several reactions characteristic of α,β-unsaturated acids (see acrylic acid). These reactions include the Diels–Alder reaction and Michael additions. Esterifications are brought about by acid-catalyzed condensations with alcohols, alkylations with certain alkenes, and transesterifications. Epoxide ring-opening gives hydroxyalkyl esters.[3] Sodium amalgam reduces it to isobutyric acid. A polymeric form of methacrylic acid was described in 1880.[10]

See also

[edit]

References

[edit]
  1. ^ International Union of Pure and Applied Chemistry (2014). Nomenclature of Organic Chemistry: IUPAC Recommendations and Preferred Names 2013. The Royal Society of Chemistry. p. 746. doi:10.1039/9781849733069. ISBN 978-0-85404-182-4.
  2. ^ a b c d e f NIOSH Pocket Guide to Chemical Hazards. "#0386". National Institute for Occupational Safety and Health (NIOSH).
  3. ^ a b William Bauer Jr. (2002). "Methacrylic Acid and Derivatives". Ullmann's Encyclopedia of Industrial Chemistry. Weinheim: Wiley-VCH. doi:10.1002/14356007.a16_441. ISBN 978-3527306732.
  4. ^ Le Nôtre, Jérôme; Witte-van Dijk, Susan C. M.; van Haveren, Jacco; Scott, Elinor L.; Sanders, Johan P. M. (September 2014). "Synthesis of Bio-Based Methacrylic Acid by Decarboxylation of Itaconic Acid and Citric Acid Catalyzed by Solid Transition-Metal Catalysts". ChemSusChem. 7 (9): 2712–2720. Bibcode:2014ChSCh...7.2712L. doi:10.1002/cssc.201402117. PMID 25045161.
  5. ^ W. P. Ratchford (1949). "Acrylic Acid I. Pyrolysis Method". Organic Syntheses. 29: 2. doi:10.15227/orgsyn.029.0002. This article also describes pyrolysis of ethyl methacrylate.
  6. ^ a b Stickler, Manfred; Rhein, Thoma (2000). "Polymethacrylates". Ullmann's Encyclopedia of Industrial Chemistry. doi:10.1002/14356007.a21_473. ISBN 3-527-30673-0.
  7. ^ "Products - Nail Care Products". www.fda.gov. U.S. Food and Drug Administration. 2018-03-06. Retrieved 2019-04-03.
  8. ^ "Aqueous enteric coatings with methacrylic acid copolymer type C on acidic and basic drugs in tablets and pellets, part I: Acetylsalicylic acid tablets and crystals".
  9. ^ Pham, Ha Q.; Marks, Maurice J. (2012). "Epoxy Resins". Ullmann's Encyclopedia of Industrial Chemistry. Weinheim: Wiley-VCH. doi:10.1002/14356007.a09_547.pub2. ISBN 978-3-527-30673-2.
  10. ^ F. Engelhorn (1880). Rudolph Fittig (ed.). "II. Untersuchungen über die ungesättigten Säuren. Zur Kenntnis der Methacrylsäure" [II. Investigations on the unsaturated acids. On the characterisation of methacrylic acid.]. Justus Liebigs Annalen der Chemie. 200: 70. doi:10.1002/jlac.18802000103..